Ip input (telco receivers) (option), Frame synchronisation, Outputs – TANDBERG High Definition Professional Recevier/Decoder TT1280 User Manual

Page 14: Transport stream outputs, Video outputs, Audio outputs, Data output, Alarm output, Band inputs (satellite receivers) (option) -6, Receivers) (option) -6

Advertising
background image

Introduction

Page 1-6

Reference Guide: TT128x High Definition Professional Receiver/Decoder

ST.RE.E10141.5

BPSK/QPSK/8PSK/16QAM (HOM) L-Band Inputs (Satellite

Receivers) (Option)

Four F-type connectors connect the L-band output of a suitable LNB either

directly or via a suitable attenuator giving lightning and surge protection.

DVB-S QPSK, DVB-S2 QPSK, 8PSK Input (Satellite

Receivers)(Option)

Four F-type connectors (TT1280/HWO/DVBS2) or Three F-type connectors

+ IF Inputs + Constellation output (TT1280/HWO/DVBS2/IF/CONST).

Connect the L-Band output of a suitable LNB either directly or via a

suitable attenuator giving lightning and surge protection.

TTV G.703 DS3 and E3 Input (Telco Receivers) (Option)

Equipped with a single BNC connector for receiving signals over a PDH

Telco network.

IP Input (Telco Receivers) (Option)

A single 10/100BaseT RJ-45 connector for receiving signals over Ethernet.

Frame Synchronisation

A BNC connector accepts a composite video input to which the video

output timing can be synchronised.

1.2.3 Outputs

Transport Stream Outputs

Two BNC connectors output ASI Transport Streams with a maximum

data rate of 160 Mbit/s, depending on the CA in use and the input card

front-end.

Video Outputs

One SVGA HD video output carried on a D-type connector.

Two digital video outputs carried on BNC connectors.

Audio Outputs

Two 9-way D-type, male connectors decode two PES streams of audio

from the Transport Stream. The audio outputs simultaneous analogue

and digital. The digital mode can be changed via the user interface.

Data Output

RS-232 asynchronous low-speed data output carried on a 9-way,

D-type, female connector.

RJ-45 high-speed data over Ethernet output (option).

RS-422 synchronous high-speed data output carried on a 9-way

D-type, female connector.

Alarm Output

A 9-way, D-type connector for interfacing to the alarm and failure

monitoring within the equipment. This includes a summary alarm signal

that coincides with the general front-panel ALARM LED.

Advertising
This manual is related to the following products: