TANDBERG High Definition Professional Recevier/Decoder TT1280 - Manual (Page 52)

Operating the Equipment Locally
Page 3-16 Reference Guide: TT128x High Definition Professional Receiver/Decoder
ST.RE.E10141.5
3.9 Setting Up the Transport Stream Output
(Menu 5)
3.9.1 Set-up Procedure
Use Table 3.21 to step through the Transport Stream Output set-up
procedure using Menu 5. This allows the Transport Stream for the current
Service to be output on the ASI output connectors.
Table 3.21: Setting Up the Transport Stream Output (TSO)
Step Action Result
1 Go to Menu 5 to enter the TRANSPORT
STREAM OUTPUT setting.
Press Edit then select one of the following:
POST INPUT (i.e. as input Transport Stream);
POST TS DESCRAMBLE (i.e. post TTV Signal Protection
and RAS descrambling);
POST ES DESCRAMBLE (i.e. post TTV,
RAS, Common Interface, BISS, DIRECTOR
descrambling).
The Transport Stream Output will be formatted according to the
choice made.
2 Press Save to store the choice. The Transport Stream Output (TSO) is now set.
3.9.2 Setting the Output Connector
Use Table 3.22 to step through the Connector configuration procedure
using Menu 5.1.
Table 3.22: Setting Up the Output Connector
Step Action Result
1 Go to Menu 5.1 to enter the Connector
configuration. Edits the Connector output function for BNC connectors 1 and 2.
2 Press Edit then select one of the following,
for each connector:
DISABLED
ASI
HD SDI
The Connectors output will be formatted according to the choice
made.
3 Press Save to store the choice. The Connector output is now set.
3.9.3 Transport Stream Output Bit-rates
The Maximum input/output rates are described in Table 3.23.
Table 3.23: Maximum Descrambled Transport Stream Output Bit-rates
Level of Descrambling TSO Setting Input Output
None POST INPUT 160 Mbit/s 160 Mbit/s
Signal Protection or RAS POST ES
DESCRAMBLE 160 Mbit/s 160 Mbit/s
Common Interface, BISS or
Director POST TS
DESCRAMBLE 55 Mbit/s 55 Mbit/s