Signal connections, General, Signal connections -10 – TANDBERG High Definition Professional Recevier/Decoder TT1280 User Manual
Page 30: General -10, Figure 2.4: typical decoder rear panel -10, 8 signal connections, 1 general
Installing the Equipment
Page 2-10
Reference Guide: TT128x High Definition Professional Receiver/Decoder
ST.RE.E10141.5
2.8 Signal
Connections
2.8.1 General
CAUTION...
It is strongly recommended that the terminal marked at the rear panel of the equipment is connected
to a site Technical Earth before any external connections are made and the equipment is powered. This
limits the migration of stray charges.
All signal connections are made via the rear panel. A typical rear panel is
shown in Figure 2.4. The connections are also shown schematically in
Figure 2.5, and a full technical specification is given in Annex B.
The Receiver provides a flexible Transport Stream input interface.
The status information appropriate to each input type is available to the
user via the User Interface, and also via the remote control interfaces.
Figure 2.4: Typical Decoder Rear Panel
Video Out
Audio 1 and 2
Frame Sync
ASI/SMPTE 310 In
10/100BaseT
Alarm Relay
Technical Earth
ASI/HDSDI OUT 1
and 2
RS-232/RS-422 Data
Out