TDK 2U GENESYS 5KW - Manual (Page 39)

83-515-000 Rev. B
31
Table 4-2: Rear panel Connections and Controls (continued)
Number Item Description Section
4
Remote Out
connector
RJ-45 type connector, used for daisy-chaining power supplies to
form a serial communication bus. 7.3
7.4
5 J1 Analog pro-
gramming and
monitoring con-
nector Connector for remote analog interface. Includes Output Voltage
and Current programming and monitoring signals, Shut-off control
(electrical signal), Enable/Disable control (dry-contact), Power
Supply OK (PS_OK) signal and operation mode (CV/CC) signal. 4.5
6 SW1 Setup
switch Nine position DIP-switch for selecting remote programming and
monitoring modes for Output Voltage, Output Current and other
control functions. 4.4
4.4.1
4.4.2
7 J2 Remote
sense connector Connector for making remote sensing connections to the load for
regulation of the load voltage and compensation of load wire
drop. 3.8.2
3.10.2
3.10.3
8 Blank Sub-plate Blank sub-plate for standard units. Isolated Remote Analog pro-
gramming connector for units equipped with Isolated Analog con-
trol option. IEEE connector for units equipped with IEEE pro-
gramming option (shown).
9 IEEE switch Two position DIP-switch for selecting IEEE mode or
RS232/RS485 mode when IEEE option is installed.
10 Ground
stud M4 stud and hardware for chassis ground connection.
4.4 REAR PANEL SW1 SETUP SWITCH
The SW1 Setup switch (see Fig.4-3) is a 9-position DIP-switch that allows the user to choose the fol-
lowing:
 Internal or remote programming for Output Voltage and Output Current.
 Remote voltage or resistive programming of Output Voltage and Output Current.
 Select range of remote voltage and resistive programming.
 Select range of output Voltage and Output Current monitoring.
 Select the Remote Shut-Off control logic.
 Select between RS232 and RS485 communication interface.
 Enable or disable the rear panel Enable/Disable control (dry contact).
Fig.4-3: SW1 setup DIP-switch
1
2
3
4
5
6
7
8
9