TDK 2U GENESYS 5KW - Manual (Page 63)

83-515-000 Rev. B
55
7.6.7 Error message
If an error is detected in command or query, the power supply will respond with an error message.
Refer to Section 7.7 for details.
7.6.8 Backspace
The backspace character (ASCII 8) clears the last character sent to the power supply.
7.7 ERROR MESSAGES
The power supply will return error messages for illegal commands and illegal programming parame-
ters. Refer to Table 7-1 for programming error messages and Table 7-2 for command error mes-
sages.
Table 7-1: Programming error messages
Error
Code
Description
E01 Returned when program voltage (PV) is programmed above acceptable range.
Example: PV above ‘105% of supply rating’ or PV above 95% of OVP setting’.
E02 Returned when programming output voltage below UVL setting.
E04 Returned when OVP is programmed below acceptable range.
Example: OVP less than 5% of supply voltage rating’ plus ‘voltage setting’.
E06 Returned when UVL is programmed above the programmed output voltage.
E07 Returned when programming the Output to ON during a fault shut down.
Table 7-2: Commands error messages
Error
Code
Description
C01 Illegal command or query
C02 Missing parameter
C03 Illegal parameter
C04 Checksum error
C05 Setting out of range
7.8 COMMAND SET DESCRIPTION
7.8.1 General guide
1.
Any command or argument may be in capital letters or small letters.
2. In commands with an argument, a space must be between the command and the argument.
3. For any command that sets a numeric value, the value may be up to 12 characters long.
4. Carriage Return: If the CR character (ASCII 13) is received by itself, the power supply will re-
spond with “OK” and CR.
7.8.2 Command set categories
The Genesys
TM
5000W series command set is divided into four categories as follows:
1. Initialization control
2. ID control
3. Output control
4. Status control