TDK 2U GENESYS 5KW - Manual (Page 51)

83-515-000 Rev. B
43
6. Connection to the load
In parallel operation, power supplies can be connected in local or remote sensing. Refer to Fig. 5-
4 and 5-5 for typical connections of parallel power supplies. The figures show connection of two
units, however the same connection method applies for up to 4 units.
5.15.2 Advanced parallel operation
In this method, multiple supplies can be configured to parallel operation as a single power supply. The
total load current and output voltage are displayed by the Master unit and can be readback from the
Master unit. The Slave units display only their operating status (On, Off or Fault condition).
Refer to the following procedure to configure multiple supplies for Advanced parallel operation.
1. Advanced parallel configuration.
a) SW1 position 2 - Down in the Master Supply and up in all Slave Supplies.
 Connect a short between J1-8 and J1-12 in all Slave Supplies.
 Connect J1-25 of the Master Supply to J1-10 of all Slave Supplies.
 Connect J1 terminal 23 (IPGM-RTN) of the slave unit to J1 terminal 12 (COM) of mas-
ter unit.
 The following set up connections are optional but are strongly recommended. These
set up and connections will shut down all the parallel power supplies when fault condi-
tion occurs in any one of them.
 Switch SW1 position 5 should be in its down position for all power supplies (See Fig.
5.6).
 Connect J1-16 of the Master Supply to J1-15 of the ‘First’ Slave Supply.
 Connect J1-16 of the ‘First’ Slave Supply to J1-15 of the ‘Second’ Slave Supply (if any)
 Connect J1-16 of the ‘Second’ Slave Supply to J1-15 of the ‘Third’ Slave Supply (if any)
 Connect J1-16 of the ‘Last’ Slave Supply to J1-15 of the Master Supply
 Connect J1-2 (or J1-3) common to all supplies (See fig. 5.6).
2. Connection to the Load
In parallel operation, power supplies can be connected in local or remote sensing. Refer to Fig. 5-
4 and 5-5 for typical connections of parallel power supplies. The figures show connection of two
units, however the same connection method applies for up to 4 units.
3. Setting the units as Master or Slave
a) Depress and hold the FINE button for 3 seconds. The Master/Slave configuration will be displayed
on the Current Display. Rotate the CURRENT encoder to obtain the desired mode. Refer to Table 5-4
for the CURRENT display and modes of operation.
CURRENT Display Operating Mode
H1 Single supply (default)
H2 Master supply with 1 Slave supply
H3 Master supply with 2 Slave supplies
H4 Master supply with 3 Slave supplies
S Slave supply
Table 5-4: Setting mode of operation
b) When the desired configuration is obtained, depress and release the FINE button or wait approx. 5
seconds.
4. Master and Slave units default operation
a) When a unit is programmed to Slave mode it enters the Remote mode with Local Lockout. In this
mode, the front panel controls are disabled to prevent accidental setting change (refer to Sec. 7.2.7
for details).
b) The Slave unit’s parameters will automatically set the following:
*Output voltage to approximate 102% of rated output voltage.
*Programmed Current to zero.
*UVL to zero volts