Ultratec PRO80 - Manual (Page 17)

Step 3
Step 2
Step 1
Step 4
Step 5
2. With the paper coming off the bottom of the roll, facing the back of the
Superprint Pro80 LVD, feed the edge of the paper into the slot on the back until it
stops.
3. Turn the Superprint Pro80 LVD on, then press the key several times until
the rollers grab the paper and feed it through the printer.
4. Feed the paper through the slot in the printer cover
and replace the printer cover.
5. The two open ends of the paper holder fit into the
holes on each side of the paper roll. Pull the two ends
apart in order to fit the paper roll between them. The
spring action of the holder will keep the paper on it.
You may need to remove the paper holder from the
Superprint Pro80 LVD in order to install the roll of
paper. To replace the paper holder, snap it back onto
the bottom of the TTY.
Enter
S E T U P • 1 1
When opening a new roll of paper.
New rolls of paper may have some glue on the first few inches. This glue,
which helps keep the paper rolled during shipment, can interfere with
printing. Make sure paper that has glue on it is fed past the printer and is
Paper Holder