Z Microsystems 8X - Manual (Page 10)

Doc# 27-0030UM Rev 1.0 Issued 12/04
10
Once both slide assemblies are installed
in the rack, extend the middle members of
the slide assemblies out of the rack. Extend the inner members of the slide as-
semblies out as far as they will go.
Press the slide locking tab on the outer
sides of the slides... and remove the inner members of the slide
assemblies.
Lay the inner members along either side
of the 8X RAID, placing the pointed end of
the members toward the rear of the unit.
This is how the inner members will be at-
tached to the 8X RAID. Attach the inner members to the sides of
the 8X RAID using 10-32 x 3/16” panhead
Phillips head screws (part# 01-91827).
Middle Slide Member Inner Slide Member
INSTALLATION