Z Microsystems 8X - Manual (Page 22)

Doc# 27-0030UM Rev 1.0 Issued 12/04
22
INSERTING THE TP7
With the handle in the open position, hold
the TranzPak 7 by the main body and
insert it partially into the docking bay. ( Be
sure that it is sliding on the black guides). Using your thumb push the TranzPak 7
gently into the bay until you can feel it
touching off on the rear connector.
Check that the locking catch is aligned with
the locking indent in the slide rail and press
the handle towards body...
OPERATIONS
until it snaps the locking handle in place.
Check that all TranzPak 7 disk modules are
aligned across the face of the 8X.