Z Microsystems 8X - Manual (Page 27)

Doc# 27-0030UM Rev 1.0 Issued 12/04
27
REPLACING THE FAN ASSEMBLY
With your fi ngers, turn the two thumb-
screws (locations shown above) counter
clockwise until the screws loosen.
Lift the fan assembly away from the Tranz-
Stor 8X chassis.
Rotate the fan assembly upward on the
hinge and then down.
To install the new fan assembly, place the
two hinges into the hinge slots (shown in
the next photo) at a 45 degree angle.
The image above shows a hinge being
inserted into the hinge slot.
Seat the assembly down and secure it in
place by simultaneously pressing and turn-
ing the thumbscrews clockwise. Tighten
the thumbscrews.
MAINTENANCE