Z Microsystems 8X - Manual (Page 28)

Doc# 27-0030UM Rev 1.0 Issued 12/04
28
Confi guring the Channels After Accidental Reset
If the controller is reset accidentally to factory default settings, follow these steps to
recover.
TROUBLESHOOTING
2. Now select “Chl 0” and then “channel Mode”, and then select “Yes”.
TROUBLESHOOTING
1. Select
“view and edit
channels”.
NOTE: Optimal setup for the RAID controller
is 0=Drive, 1=Drive, 2=Host,
3=Host. Only follow these steps if these
parameters are not already setup.