Z Microsystems 8X - Manual (Page 11)

Doc# 27-0030UM Rev 1.0 Issued 12/04
11
Slide the unit in until the slide action stops. Hold the 8X RAID up to the extended
rails with the rear of the 8X RAID to the
rear of the rack. Insert the inner member
(attached to the 8X RAID) into the middle
member of the slide.
CAUTION: When attaching the inner
members of the slide assemblies
to the sides of the 8X RAID,
ensure screw penetration
does not exceed 3/16” length.
Damage may result if screw
length exceeds 3/16” length.
Use 10-32 x 3/16” screws only
(part# 01-91827).
STEP 2: 8X RAID INSTALLATION
Secure the front of the 8X RAID to the rack
with three 8-32 x .75” panhead Phillips
screws on each side. See image above. Simultaneously press the slide locking tab
in and push the unit all the way back into
the rack.
INSTALLATION