Z Microsystems 8X - Manual (Page 13)

Doc# 27-0030UM Rev 1.0 Issued 12/04
13
STEP 5: ESTABLISH
SERIAL CONNECTION
From Accessories/Comunications/ select
Hyperterminal. Create description, select
COM Port and fi ll in Port Settings as
follows:
Bits per seconds: 38400
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None •
•
•
•
•
Before powering the TranzStor 8X, make sure all of the connections are tightened se-
curely at the rear of the unit.
STEP 4: POWER UP TRANZSTOR 8X
Power Switch, Front
Then press the power switch on the front of the 8X.
OPERATIONS
After turning on the power switch, the controller will beep. Watch the amber activity lights.
All of the drives’ activity LEDs will illuminate briefl y, and then extinguish.