Z Microsystems 8X - Manual (Page 8)

Doc# 27-0030UM Rev 1.0 Issued 12/04
8
REQUIRED TOOLS
• Phillips Head Screwdriver
• 3/8” ratchet
NOTE: For the fastest and easiest
installation of the 8X, follow
these steps in the sequence they
are presented.
PREPARATIONS
In preparation to install the 8X, take the
following precautionary steps:
Turn off the electrical power to the host
computer.
INSTALLATION
PRECAUTIONS
When mounting the 8X, there is a
maximum of .18” screw penetration on the
underside and side screw hole locations.
INSTALLATION