Xerox NS-2260 - Manual (Page 105)

5.5.4 Port Controls
This page allows to change per port configuration settings as follows:
Port : Select the ports to perform setup. More than one port can be selected at the same time for setup.
See next page for control settings.
Note:
All default values displayed for setup are not current setting values, but the factory default values instead.
The current values for the selected ports are displayed beneath [Apply] button.
Control settings:
State : Disable or enable this port function.
Auto Negotiation : Set auto negotiation mode for this port, options -
Auto = enable auto negotiation with the highest capability
Nway = enable auto negotiation with the specified capability
Force = disable auto negotiation and use forced mode
Speed : Set speed for this port (the highest capability if Auto mode)
Port 1- 24 options : 100, 10
G1, G2 ports options : 1000, 100, 10 (depends on module type)
Duplex : Set duplex mode for the selected port, options -
Full = Full duplex