Xerox NS-2260 - Manual (Page 80)

3.5.1 Port Status
-------------------------------------------------------------------------
Managed 24+2G Switch : Port Configuration
Link InRate OutRate Flow
Port Status (100K) (100K) Enable Auto Spd/Dpx Control
------------------------------------------------------------------
PORT1 Down 0 0 No AUTO 100 Full On
PORT2 Down 0 0 No AUTO 100 Full On
PORT3 Down 0 0 No AUTO 100 Full On
PORT4 Down 0 0 No AUTO 100 Full On
PORT5 Up 0 0 Yes AUTO 100 Full Off
PORT6 Down 0 0 No AUTO 100 Full On
PORT7 Down 0 0 No AUTO 100 Full On
PORT8 Down 0 0 No AUTO 100 Full On
action-> <Quit> <Previous Page> <Next Page>
-------------------------------------------------------------------------
This page display current port status for all switched ports. The status are:
Link Status : Display port link status
InRate : Display the input rate control (100K/unit) setting value.
OutRate : Display the output rate control (100K/unit) setting value.
Enable : Display the port function setting. (Yes=Port is enabled, No=Port is disabled)
Auto : Display the port Nway mode: Auto , Nway_Force , Force.
Spd/Dpx : Display the port speed and duplex status.
FlowControl : Display the flow control status.
Note:
In auto / Nway force mode, it displays the flow control status after negotiation. In force mode, it displays
the flow control setting.