Xerox NS-2260 - Manual (Page 36)

2.7.2 Setup for In-band Management
To perform an in-band management, it is necessary to connect the system to your TCP/IP network. The
steps are:
1. Configure IP and SNMP related settings to the device using direct console management when you
receive it first time for the installation.
2. Find a proper straight-through Category 5 UTP cable (maximal length 100 meters) for the connection.
3. Connect one end of the UTP cable to the UTP port of the media converter and connect the other end to a
network device, such as a switching hub, in your TCP/IP network.
4. Start your in-band management operations. For different management methods, refer to:
_ Chapter 3 for Console and Telnet management
_ Chapter 4 for SNMP management
_ Chapter 5 for Web management
2.7.3 Quick Guide to Configure Switch IP Address
This section provides a quick instruction to configure a new IP address via Console port for the switch
received for the first time. The steps are:
1. Set up console connection as described in section 2.7.1.
2. Login with default username= admin and password=123.
3. Menu selections to enter IP configuration as follows:
Main Menu
-> Switch Static Configuration
-> Administration Configuration
-> IP Configuration