Xerox NS-2260 - Manual (Page 43)

Port : Port number
Display names - PORT1 - PORT24, G1 - G2
Type : Port type
Display names - 100Tx, 100FX, 1000T, 1000FX
InRate : Input (Ingress) rate control setting, 100Kbytes per unit.
Options - 0 = disable rate control, 1 ~ 1000 valid rate value
OutRate : Output (Egress) rate control setting, 100Kbytes per unit
Options - 0 = disable rate control, 1 ~ 1000 valid rate value
Enable : Port function enable / disabled control setting
Options - Yes=Enable, No=Disable
Auto : Port auto negotiation mode control setting
Options - Auto, Nway_Force, Force
Spd/Dpx : Port speed and duplex configuration control setting
Flow Control / Full : Full duplex flow control (Pause frame) setting
Options - On=Enable, Off=Disable
Flow Control / Half : Half duplex flow control (Backpressure) setting
Options - On=Enable, Off=Disable
Note:
1. Port 25 (G1 slot) and Port 26 (G2 slot) are not displayed if no module is installed in the slot.
2. Input (Ingress) Rate control function works only when the port and its link partner operate with flow
control enabled.