Xantrex Technology LINK 10 - Manual (Page 20)

20
Pressing and holding the SET button for three seconds enters the Setup and
Advanced Functions mode. The word SEL
SEL SEL SEL SEL apppears in the display, prompting you
to press the SEL button to choose what function you want to SELect.
Pressing SEL chooses a variable or function. The SETUP mode always begins
at the
(Volts) function. Each press of the SEL button scrolls to the next item.
When a variable or function is selected, its LED is on and its present value is
displayed. To change an item press the SET button until the value appears that
you wish. The order displayed and brief descriptions are below.
LIGHT DESCRIPTION
Charged Voltage (the voltage above which the battery must rise to be full)
Charged Current % (charging current must be below this percentage times
the battery capacity to be considered full. See page 22–23)
Battery Capacity in amp hours
Time interval over which current is averaged for time remaining function.
Using the Buttons
Advanced Functions. See page 30.
Locks out SET button & Advanced Functions. See
page 28.
Displays: CEF, # CEF Recalcs, Average Depth of
Discharge, Deepest Discharge, Average Rate of
Discharge. See page 29.
Resets A-hrs & allows Reset to Factory values. See
page 28.
Each LED is lit in sequence to indicate function.