ZyXEL Communications ES-3124PWR - Manual (Page 199)

Dimension ES-3124PWR Ethernet Switch
Introducing the Commands 29-5
29.6 Command Modes
There are three CLI command modes: User, Enable and Configure.
When you first log into the CLI, the initial command mode is the User mode. The User mode commands are a
subset of the Enable mode commands. The User mode command prompt ends with an angle bracket (>).
To enter Enable (or privileged) mode, type “ enable ” and enter a password when prompted (the default is 1234).
When you enter the Enable mode, the command prompt changes to the pound sign ( # ).
To enter the configuration mode, type “ configure ” or “ config ”. The Configure mode command prompt consists
of the word “ config ” and the pound sign ( # ). There are two sub configuration modes: VLAN and interface. To
enter config-vlan mode, type “ vlan ” followed by a number (between 1 to 4094). For example, vlan 10 . To enter
config-interface mode, enter interface followed by a port number. For example, interface 10 .
Enter “ exit ” or “ logout ” to quit from the current mode or log out from the CLI.
29.7 Using Command History
The switch keeps a list of up to 256 commands(s) you have entered for the current CLI session. You can use any
commands in the history again by pressing the up (y) or down (z) arrow key to scroll through the previously used
commands and press [ENTER]. Use the history command to display the list of commands.
Figure 29-7 CLI: History Command Example
29.8 Saving Your Configuration
After you set the switch settings with the configuration commands, use the write memory command to save the
changes permanently.
Figure 29-8 CLI: write memory
The write memory command is not available in User mode.
You must save your changes after each CLI session. All unsaved configuration changes are lost
once you restart the switch.
29.8.1 Logging Out
In User mode, enter the exit or logout command to log out of the CLI.
ras# write memory
ras> history
enable
exit
show ip
history
ras>