ZyXEL Communications ES-3124PWR - Manual (Page 39)

Dimension ES-3124PWR Ethernet Switch
Hardware Connections 3-5
Figure 3-5 Transceiver Removal Example
3.1.5 Management Port
The MGNT (management) port is used for local management. Connect directly to this port using a STP (Shield
Twisted-Pair) cable. You can configure the switch via Telnet or the web configurator.
The default IP address of the management port is 192.168.0.1 with a subnet mask of 255.255.255.0
3.2 Rear Panel
The following figure shows the rear panel of the ES-3124PWR. The rear panel contains the ventilation holes, a
connector for external backup power supply (BPS) and the power receptacle.
Figure 3-6 ES-3124PWR Rear Panel
3.2.1 Power Connector
Make sure you are using the correct power source as shown on the panel.
To connect the power to the ES-3124PWR, insert the female end of power cord to the power receptacle on the rear
panel. Connect the other end of the supplied power cord to a 100~240VAC/10A power outlet. Make sure that no
objects obstruct the airflow of the fans (located on the side of the unit).
3.2.2 External Backup Power Supply Connector
The switch supports external backup power supply (BPS).