ZyXEL Communications ES-3124PWR - Manual (Page 71)

Dimension ES-3124PWR Ethernet Switch
Basic Setting 6-7
Click Basic Setting and then Switch Setup in the navigation panel display the screen as shown. The VLAN setup
screens change depending on whether you choose 802.1Q or Port Based in the VLAN Type field in this screen.
Refer to the chapter on VLANs.
Figure 6-3 Switch Setup
The following table describes the labels in this screen.
Table 6-3 Switch Setup
LABEL DESCRIPTION EXAMPLE
VLAN Type Choose 802.1Q or Port Based. The VLAN Setup screen changes depending on
whether you choose 802.1Q VLAN Type or Port Based VLAN Type in this
screen. See Section 6.4 and the VLAN chapter for more information on VLANs. 802.1Q
IGMP
Snooping Select Active to enable IGMP snooping. See Section 6.5 for more information on
IGMP snooping.
Bridge control
protocol
transparency Select Active to allow the switch to handle bridging control protocols (STP for
example). You also need to define how to treat a BPDU in the Port Setup
screen.
MAC Address
Learning MAC address learning reduces outgoing traffic broadcasts. For MAC address
learning to occur on a port, the port must be active.