ZyXEL Communications ES-3124PWR - Manual (Page 218)

Dimension ES-3124PWR Ethernet Switch
29-24 Introducing the Commands
Table 29-5 Command Summary: Interface
COMMAND DESCRIPTION
mirror Enables port mirroring in the
interface.
mirror dir <ingress|egress|both> Enables port mirroring for
incoming, outgoing or both
incoming and outgoing traffic.
Port mirroring copies traffic from
one or all ports to another or all
ports for external analysis.
speed-duplex <auto|10-half|10-full|100-
half|100-full|1000-full>
Sets the duplex mode (half, full)
and speed (10/100/1000 Mbps)
of the connection on the
interface. Selecting auto (auto-
negotiation) makes one port able
to negotiate with a peer
automatically to obtain the
connection speed and duplex
mode that both ends support.
bpdu-control <peer|tunnel|discard|network> Sets how Bridge Protocol Data
Units (BPDUs) are used in STP
port states.
no ingress-check Incoming traffic is not checked
for VLAN tags.
no gvrp Disables GVRP on the switch.
no flow-control Disables flow control on the
switch.
no vlan-trunking Disables VLAN trunking on the
switch.
no mirror Disables port mirroring on the
switch.
no bandwidth-limit Disables bandwidth limit on the
switch.
no broadcast-limit Disables broadcast storm control
limit on the switch.
no multicast-limit Disables multicast limit on the
switch.
no dlf-limit Disables destination lookup
failure (DLF) on the switch.
no inactive Enables the specified interface
on the switch.
no intrusion-lock Disables intrusion-lock on a port
so that a port can be connected
again after you disconnected the
cable.
inactive Disables the specified interface
on the switch