Smart Technologies FSSBID 100 - Manual (Page 17)

99-00962-20 REV C0
7 | A B O U T Y O U R S M A R T M O B I L E S T A N D
Power Specifications
Your SMART Mobile Stand’s user friendly power management design
accommodates up to 1.2 kW and includes the following features:
• A country-specific power bar—North America (NEMA) 110V AC
or IEC 240V, 50 Hz—which provides power access for additional devices
near the bottom rear of your stand
• An 8' (2.44 m) country-specific power cord (international only)
• A country-specific extension cable
• Country-specific power adapters
• A USB 2.0 cable
Hardware and Internet Connection
Requirements
Computer Hardware
You need at least three USB receptacles (recommended) on your computer
to connect it to your SMART Mobile Stand. If your computer has fewer than three
available USB receptacles, you need a USB hub (not included) to connect
your computer to your stand.
Local Area Network (LAN) Connection (Optional)
Your SMART Mobile Stand includes a standard RJ45 LAN connection point
to connect your computer to your network. You need an external source so that
you can access the Internet.
Determining Your Model of
SMART Mobile Stand
Your SMART Mobile Stand is either a standard model (FSSBID 100), or one that
includes support for a SMART Hub SE240 (FSSBID 100H). You can determine your
model of SMART Mobile Stand by referring to its serial number, which is located on
the back, right-hand side of your unit’s speaker panel, near the top:
• If you have model FSSBID 100, the serial number follows the format
FSSBID1-R2-XXXXX, where X is any number.
• If you have model FSSBID 100H, the serial number follows the format
FSSBID1H-R2-XXXXX, where X is any number.