Smart Technologies FSSBID 100 - Manual (Page 81)

99-00962-20 REV C0
7 1 | C O N F I G U R I N G A R A C K M O U N T
4. Remove the two installed shelves from the cabinet, and then remove the eight
shelf clips.
5. Locate the cabinet’s rear support tube, remove the two screws in the flange
at the top, and then lift the tube at a slight angle to detach and remove it
from the base of the unit.
NOTE
You may need to detach some cables to remove this support tube.
After you finish configuring your SMART Mobile Stand to accommodate
a rack mount, attach these cables again.
2Ч
8Ч
2Ч
Rear Support Tube