Smart Technologies FSSBID 100 - Manual (Page 38)

2 8 | M O D E L F S S B I D 1 0 0 : C O N N E C T I N G D E V I C E S I N S I D E Y O U R S M A R T M O B I L E
S T A N D ’ S C A B I N E T
99-00962-20 REV C0
Connecting Your SMART Board interactive
display frame
This section describes how to connect your SMART Board interactive display frame’s
controller box to your SMART Mobile Stand (instead of directly to a computer).
Refer to the SMART Board interactive display frame Installation and User’s Guide
( document 125254 at www.smarttech.com/support ) for general instructions
on installing your SMART Board interactive display frame on your flat-panel display.
NOTE
You don’t need the USB cable included with your SMART Board interactive
display frame to complete the following procedure.
To connect your
interactive display frame
1. Rotate your SMART Mobile Stand’s height-adjustment handle to raise
your flat-panel display to its highest position.
2. Working inside your SMART Mobile Stand’s cabinet from the back, secure your
SMART Board interactive display frame’s controller box to the mounting holes
on the left side of the connection panel with the four screws included in your
stand’s accessory kit.
IMPORTANT
Ensure that the controller box’s LEDs face downward.