Smart Technologies FSSBID 100 User Manual
Page 59
99-00962-20 REV C0
4 9
|
M O D E L F S S B I D 1 0 0 H : C O N N E C T I N G D E V I C E S I N S I D E Y O U R S M A R T M O B I L E
S T A N D ’ S C A B I N E T
NOTE
You previously connected the other end of this cable to your
SMART Hub SE240 (see page 44).
3.
Connect your DVD or Blu-ray player’s power cable (not included) to an available
receptacle on your SMART Mobile Stand’s power bar.
TIP
Coil and bundle the cable with the included hook-and-loop fastener strap.
NOTE
Don’t connect your SMART Mobile Stand to a power outlet before you install
the rear access panels (page 58).
To connect
your VCR
1.
Connect the three-plug RCA cable AV02 as follows:
–
Connect the yellow plug to your VCR’s yellow
receptacle, which is typically labeled V or VIDEO.
–
Connect the red audio plug to your VCR’s
appropriate red receptacle, which is typically
labeled R.
–
Connect the white audio plug to your VCR’s white
receptacle, which is typically labeled L.
NOTE
You previously connected the other end of this cable
to your SMART Hub SE240 (see page 44).
2.
Connect your VCR’s power cable (not included) to an
available receptacle on your SMART Mobile Stand’s power bar.
TIP
Coil and bundle the cable with the included hook-and-loop fastener strap.
NOTE
Don’t connect your SMART Mobile Stand to a power outlet before you install
the rear access panels (page 58).
Cable
AV02