Smart Technologies FSSBID 100 - Manual (Page 36)

2 6 | M O D E L F S S B I D 1 0 0 : C O N N E C T I N G D E V I C E S I N S I D E Y O U R S M A R T M O B I L E
S T A N D ’ S C A B I N E T
99-00962-20 REV C0
To connect your
DVD/Blu-ray player
1. Connect the five-plug RCA cable AV03, or your
HDMI cable, as follows:
– Connect the RGB red video plug to your DVD
or Blu-ray player’s appropriate red receptacle,
which is typically labeled Pr or R.
IMPORTANT
Do not confuse the RGB red video plug
with the red audio plug.
– Connect the RGB blue video plug to your DVD
or Blu-ray player’s blue receptacle, which is
typically labeled Pb or B.
– Connect the RGB green video plug to your
DVD or Blu-ray player’s green receptacle,
which is typically labeled Y or G.
– Connect the red audio plug to your DVD or Blu-ray player’s remaining red
receptacle, which is typically labeled R.
– Connect the white audio plug to your DVD or Blu-ray player’s white
receptacle, which is typically labeled L.
NOTE
You previously connected the other end of this cable to your
flat-panel display (see page 20).
2. Connect your DVD or Blu-ray player’s power cable (not included with your
SMART Mobile Stand) to an available receptacle on your SMART Mobile Stand’s
power bar.
TIP
Coil and bundle the cable with the included hook-and-loop fastener strap.
NOTE
Don’t connect your SMART Mobile Stand to a power outlet before you install
the rear access panels (page 58).
Cable
AV03