Smart Technologies FSSBID 100 - Manual (Page 62)

5 2 | M O D E L F S S B I D 1 0 0 H : C O N N E C T I N G D E V I C E S I N S I D E Y O U R S M A R T M O B I L E
S T A N D ’ S C A B I N E T
99-00962-20 REV C0
7. Route your interactive display frame’s camera cables through the connection
panel from the right side, up your SMART Mobile Stand’s prewired cable harness,
down behind the speaker panel and along the inside edge of the pencil ledge,
as shown on page 53.
TIPS
– To route the camera cables, remove the plastic cable ties securing the
cable harness to your SMART Mobile Stand’s top horizontal mounting bar,
remove the nylon sleeve, and then loosen all the hook-and-loop fastener
straps.
– Remove each plastic cable tie by pressing down on the plastic tab
while you pull the tie backward.
– After you route the camera cables, secure them together with the rest
of the cables with the hook-and-loop fastener straps and nylon sleeve,
and then secure the cable bundle to the top horizontal mounting bar
with the plastic cable ties.
8. Connect the camera cables to your frame’s bottom corner blocks.