Smart Technologies FSSBID 100 - Manual (Page 44)

3 4 | M O D E L F S S B I D 1 0 0 : C O N N E C T I N G D E V I C E S I N S I D E Y O U R S M A R T M O B I L E
S T A N D ’ S C A B I N E T
99-00962-20 REV C0
3. Connect the DB9 end of the SMART DB9 to USB adapter cable (included with
your SMART Board for Flat-Panel Displays interactive overlay) to your pen tray,
ensuring that you can still easily access the USB A plug at the other end.
TIPS
– First route this adapter cable through your SMART Mobile Stand’s
connection panel and up the prewired cable harness.
– Leave some slack throughout the length of this cable. Don’t pull it tight.
– Coil the excess cable and fasten it to the lower right clip on your
SMART Mobile Stand’s speaker panel with plastic cable ties.
4. Connect the USB plug that you left accessible in the previous step to the
USB A receptacle of adapter AD09, which you purchased for your
SMART Mobile Stand (as shown on page 32).
NOTE
Don’t connect the SMART DB9 to USB adapter cable included with
your SMART Board for Flat-Panel Displays interactive overlay to your
computer, as instructed in the SMART Board for Flat-Panel Displays
Installation Guide.
5. If you’ve connected either a computer or a SMART Hub
PE260 to your SMART Mobile Stand, remove the plastic
cable tie from the USB B male cable (marked C04) in
your SMART Mobile Stand’s prewired cable harness, and
then connect it to the other end of the adapter
that you purchased for your unit (as shown on page 32).
NOTE
The other end of cable C04 is prewired to your
SMART Mobile Stand’s connection panel.
TIP
Secure cable C04 to the SMART DB9 to USB adapter cable included
with your interactive overlay with a plastic cable tie.
6. Connect your interactive overlay’s power cable (included with your interactive
overlay) to the right side of its power supply.
USB B Cable C04