Smart Technologies FSSBID 100 - Manual (Page 20)

1 0 | A S S E M B L I N G Y O U R S M A R T M O B I L E S T A N D
99-00962-20 REV C0
Environmental Requirements
Before installing your SMART Mobile Stand, refer to the following
environmental requirements.
CAUTION
• Never operate your SMART Mobile Stand immediately after moving it
from a cold location to a warm location. Allow the unit to reach room
temperature before operation to prevent possible product damage.
• Do not place your SMART Mobile Stand in hot locations, such as near
heating equipment.
• Do not block the ventilation slots and openings on your SMART Mobile Stand.
Blocking these openings could cause overheating and damage to the unit.
Environmental Requirement Parameter
Operating Temperature 41°F to 86°F (5°C to 30°C)
Storage Temperature -40°F to 140°F (-40°C to 60°C)
Humidity 5–80% relative humidity, non-condensing
Water and Fluid Resistance • Intended for indoor use
• Don’t pour or spray liquids directly
on the electronic components.
Dust • Moderate dust
• Designed for pollution degree 1 (P1)
as per EN61558-1, which is defined
as “No pollution or only dry
non-conductive pollution”
• Refer to page 67 for instructions
on periodically cleaning your
SMART Mobile Stand.
Conducted and Radiated Emissions EN55022/CISPR 22, Class B
Flammability Rating • Plastics: HB
• USB 2.0 cable: UL VW-1/CSA FT4
Quality Assembly • USB cable: IPC/WHMA-A-620 Class 2
workmanship standards for
Requirements & Acceptance for Cable
& Wire Harness