Smart Technologies FSSBID 100 - Manual (Page 43)

99-00962-20 REV C0
3 3 | M O D E L F S S B I D 1 0 0 : C O N N E C T I N G D E V I C E S I N S I D E Y O U R S M A R T M O B I L E
S T A N D ’ S C A B I N E T
Cable Connections to Your Interactive Overlay
To connect your
interactive overlay
1. Working inside your SMART Mobile Stand’s cabinet from the back, secure
your interactive overlay’s power supply to the two mounting holes directly
to the right of the connection panel, using plastic cable ties.
IMPORTANT
Position this power supply so that the power cable is on the left side.
2. Connect the power cable and connector from this power supply to your
interactive overlay’s power port.
TIPS
– Route this power cable through your SMART Mobile Stand’s connection
panel and up the prewired cable harness.
– Leave some slack throughout the length of this cable. Don’t pull it tight.
Cable C04
USB A to B Adapter AD09
Power Cable to Your
SMART Board
for Flat-Panel Displays
Interactive Overlay’s
Pen Tray
Power Cable to Power Supply
Coil the DB9 to
USB adapter
cable’s excess
length, fasten it
to a clip on the
speaker panel
with a plastic
cable tie, and
then secure this
adapter cable to
cable C04 with
another plastic
cable tie.