Smart Technologies FSSBID 100 - Manual (Page 6)

i v | I M P O R T A N T I N F O R M A T I O N
99-00962-20 REV C0
• Do not block the ventilation slots and openings on your SMART Mobile Stand.
Blocking these openings could cause overheating and damage to the unit.
• When transporting your unit, repack it with as much of the original packaging
as possible. This packaging was designed with optimal shock and
vibration protection.
• Do not allow liquids, spray cleaners or commercial solvents of any kind to flow
into the connection panel.
• Do not attempt to service your SMART Mobile Stand. Only an authorized
service provider should service your SMART Mobile Stand.
• If your wired keyboard, mouse or other USB device is damaged while it is
attached to your SMART Mobile Stand, SMART assumes no responsibility
and you are solely responsible for this damage.
Other Precautions
If you own a SMART product other than your SMART Mobile Stand for interactive
displays, refer to the other product’s documentation for relevant safety warnings
and maintenance instructions.
To ensure operating safety and to prevent product damage, observe the following
precautions:
• Do not set up or use your SMART Mobile Stand in an area with excessive levels
of dust, dirt, humidity or smoke.
• Disconnect your SMART Mobile Stand’s power plug from the power outlet before
cleaning the unit or if you won’t be using it for a long period of time.
• Use a soft cloth moistened with a mild detergent to clean the unit’s housing.
• If your SMART Mobile Stand requires replacement parts, make sure that the
service technician uses replacement parts specified by SMART Technologies.