Smart Technologies FSSBID 100 - Manual (Page 68)

5 8 | C O M P L E T I N G Y O U R I N S T A L L A T I O N A N D C O N N E C T I N G O T H E R P R O D U C T S
T O Y O U R S M A R T M O B I L E S T A N D
99-00962-20 REV C0
Installing the Rear Access Panels on Your
SMART Mobile Stand
After you connect your computer or SMART Hub, and perhaps your DVD/Blu-ray
player or VCR, to your SMART Mobile Stand, reinstall the rear access panels
on your unit.
To install the rear
access panels
1. Replace the upper rear panel that you removed from your SMART Mobile Stand,
secure the bottom two screws with the included security TORX® key, and then
secure the top two screws with a Phillips No. 2 screwdriver.
2. Replace the lower rear panel that you removed, and then secure all four screws
with the included security TORX key.
CAUTION
Take care to properly route the power cables through the two cutouts
in the bottom of the lower rear panel so that you do not damage the cables.
3. Connect your SMART Mobile Stand’s power cable to a power outlet.
A
B