RIDGID NaviTrack II - Manual (Page 19)

NaviTrack® II
18
Display Elements Menu
Selecting the icon representing two small display screens will
bring up the Display Selection Menu for either Trace
or
Sonde mode. This control is used to turn screen elements
on and off. The NaviTrack® II is shipped with some of the
elements turned off for simplicity. To turn an element on or
off, press the up or down arrow to highlight the selection then
use the select key to check or uncheck the box. Checked display
elements are turned on for the selected mode
Figure 30: Screen Elements (Sonde Mode)
Optional Features
Advanced features of the NaviTrack® II can be turned on by
using the Menu key to show the menu tree. Select the Display
Elements selection menu (for display elements – described on
page 18) or the Frequency Selection menu (to activate other
frequencies – described on page 8).
Optional Features include:
Figure 31: Racetrack with Watermark and Pointer
• Watermark
The watermark is a marker which appears in the outer ring of
the display. It is a graphic representation of the highest signal
strength reached. It is “chased” by a solid pointer which shows
the current signal strength. If the signal strength pointer
goes higher than the watermark, the watermark moves up
accordingly to show the new highest level graphically.
It is turned off by default but can be turned on in the Display
Elements selection menu.
Figure 32: “No-Signal” Display
• No-Signal Icon
When the NaviTrack® II is not receiving any meaningful signal
on the selected frequency it will display the mode sign with
a line through it, indicating no signal is being detected. This
reduces the confusion of trying to interpret the random noise
that some locators display in the absence of a signal.
Figure 33: Signal Strength Centered
• Center Signal Strength Option
Turning the option on in the Menu Selection screen will force
the number representing signal strength to be displayed
in the center of the display area anytime when no Proximity
Signal is available. This may occur when signal is weak. When a
Proximity Signal again becomes available, the signal strength
number returns to the lower right corner of the screen as usual.
(Line Trace Mode only.)