RIDGID NaviTrack II - Manual (Page 20)

NaviTrack® II
19
• Information Screen
The information screen appears at the bottom of the menus
choices list. Pressing the Select button displays information
about the locator, including software version, serial number of
the receiver, and its calibration date. Pressing Select a second
time will display the Restore Factory Defaults option.
• Restore Factory Defaults
This option is turned on by selecting the checked box (√). If
the “X” option is chosen, no change from current settings will
be made.
Figure 34: Defaults Restored (Line Trace Mode)
Pressing the Menu key without changing either checkbox will
exit the option and leave things as they were.
• Sound Muting > 99’
This option enables the automatic muting of the sound when
the depth is greater than 99 feet. If it is unchecked, the sound
will not mute automatically.
Menu Tree
The following graphic shows the options and controls built into
the NaviTrack® II menus. Pressing the menu key from the active
screen moves the display to the top of the menu tree. Move
through the choices using the arrow keys. Pressing the Select
key when any choice is highlighted will show that submenu.
Pressing the menu key within a sub-menu will move up one
level. Checkboxes are turned on and off by pressing the Select
key.
Activated Frequencies
Sonde
Line Trace
Power (Passive Trace)
Units of Measure
Feet/Meters
Backlight Options
On/Off/Auto
LCD Contrast
Increase/Decrease
Display Elements Select
(Check On/Off)
Trace Mode Sonde Mode
Watermark
No-Signal Indicator
Sound Signals
Center Signal Strength*
Signal Strength
Angle Indicator
Mute > 99’
Tracing Lines*
*=Line Tracing Display Only
Frequency Select (Check On/Off)
Sonde
16 Hz, 512 Hz, 640 Hz, 850 Hz, 8 kHz,
16 kHz, 33 kHz
Line trace
128 Hz, 1 kHz, 8 kHz, 33 kHz, 200 kHz,
262 kHz
Power
50 Hz, 60 Hz
Information Menu
Restore Default Settings
(Check Yes/No)