Garmin GNS 430 - Manual (Page 137)

GNS 430(A) Pilot’s Guide and Reference 190-00140-00 Rev. P 7-21
SECTION 7
WPT PAGES
To modify a user waypoint by changing
reference waypoint information:
1) With the User Waypoint Page displayed, press
the small right knob to activate the cursor.
2) Use the small and large right knobs to enter
the name of the desired waypoint and press
the ENT Key.
3) Turn the large right knob to highlight the first
reference waypoint (REF WPT) field, to change
the reference waypoint. Otherwise, continue
turning the large right knob to highlight
the radial (RAD) or distance (DIS) field, as
desired.
4) Use the small and large right knobs to change
the identifier (if desired) of the reference
waypoint (Figure 7-46). The reference waypoint
can be an airport, VOR, NDB, intersection, or
another user waypoint. Press the ENT Key to
accept the selected identifier.
Figure 7-46 Ref Waypoint Field Selected
5) The cursor moves to the radial (RAD) field
(Figure 7-47). Use the small and large right
knobs to change the radial from the reference
waypoint, if desired. Press the ENT Key to
accept the selected radial.
Figure 7-47 Radial Field Selected
6) The cursor moves to the distance (DIS) field
(Figure 7-48). Use the small and large
right knobs to change the distance from the
reference waypoint to the new user waypoint,
if desired. Press the ENT Key to accept the
selected distance.
Figure 7-48 Distance Field Selected
7) The cursor moves to the ‘Modify?’ action field.
Press the ENT Key to modify the waypoint.
8) Press the small right knob to remove the
flashing cursor.
NOTE: If the pilot attempts to modify or delete a
waypoint which is currently a direct-to waypoint
or the current ‘from’ or ‘to’ waypoint in the active
flight plan, the GNS 430 alerts the pilot with the
‘Can’t change an active waypoint’ or ‘Waypoint
is active and can’t be deleted’ message. The
pilot must first cancel the direct-to or remove
the waypoint(s) from the active flight plan before
modifying or deleting the waypoint(s).