Garmin GNS 430 - Manual (Page 139)

GNS 430(A) Pilot’s Guide and Reference 190-00140-00 Rev. P 7-23
SECTION 7
WPT PAGES
User Waypoint List
The User Waypoint List (Figure 7-52) allows the
pilot to review, modify, rename, or delete a selected user
waypoint, or to delete all user waypoints currently stored
in memory. The top of the page shows the number of
waypoints used and available memory.
To review and/or modify a user waypoint
from the User Waypoint List:
1) Select the User Waypoint List, as described in
this section.
2) Turn the large right knob to highlight the
desired user waypoint (Figure 7-52).
Figure 7-52 User Waypoint List Page
3) Press the ENT Key to display the User Waypoint
Page for the selected waypoint. From this page
the pilot may review all information defining
the waypoint and its position.
4) To modify the waypoint’s position or reference
waypoint information, follow the steps
described in this section.
5) To exit the User Waypoint Page, turn the large
right knob to highlight ‘Done?’ and press the
ENT Key.
To rename a user waypoint from the User
Waypoint List:
1) Select the User Waypoint List, as described in
this section.
2) Turn the large right knob to highlight the
desired user waypoint.
3) Use the small and large right knobs to change
the name of the user waypoint (Figure 7-53).
Enter the new name directly over the old name.
Press the ENT Key to accept the new name.
Figure 7-53 User Waypoint Name Selected
4) A ‘rename waypoint’ confirmation window
is displayed (Figure 7-54). With ‘Yes?’
highlighted, press the ENT Key to rename the
selected user waypoint.
Figure 7-54 Rename Waypoint Window