Garmin GNS 430 - Manual (Page 174)

GNS 430(A) Pilot’s Guide and Reference 190-00140-00 Rev. P 10-16
SECTION 10
AUX PAGES
4) For a count down timer, turn the large right
knob to highlight the time field. Use the small
and large right knobs to enter the count down
time—in hours, minutes, and seconds. Press
the ENT Key when finished.
5) To stop the generic timer, turn the large right
knob to highlight ‘Stop?’ and press the ENT
Key.
6) To reset the generic timer, turn the large right
knob to highlight the time field. Press the CLR
Key, followed by the ENT Key.
To record or reset the departure time:
1) Select ‘Flight Timers’ from the Utility Page,
using the steps described at the beginning of
this section (10.3).
2) Turn the large right knob to highlight the reset
mode field, under ‘Departure Time’. The reset
mode field indicates ‘Pwr-on’ or ‘GS>30kt’.
3) Turn the small right knob to select the desired
reset mode (Figure 10-38). ‘Pwr-on’ records
a departure time when the GNS 430 is turned
on. ‘GS>30kt’ records a departure time once
the GPS-computed ground speed exceeds 30
knots.
Figure 10-38 Reset Mode Window
4) Press the ENT Key when finished.
5) To reset the departure time, turn the large right
knob to highlight ‘Reset?’ and press the ENT
Key.
To view, use or reset total trip time:
1) Select ‘Flight Timers’ from the Utility Page,
using the steps described at the beginning of
this section.
2) Turn the large right knob to highlight the reset
mode field, under ‘Total Trip Time’. (The reset
mode field indicates ‘Pwr-on’ or ‘GS>30kt’.)
3) Turn the small right knob to select the desired
reset mode. ‘Pwr-on’ records trip time, in
hours/minutes/seconds, any time the GNS 430
is turned on. ‘GS>30kt’ records trip time any
time the GPS-computed ground speed exceeds
30 knots.
4) Press the ENT Key when finished.
5) To reset the total trip time, turn the large right
knob to highlight ‘Reset?’ (Figure 10-39) and
press the ENT Key.
Figure 10-39 ‘Reset?’ Highlighted