Garmin GNS 430 - Manual (Page 244)

GNS 430(A) Pilot’s Guide and Reference 190-00140-00 Rev. P
SECTION 14 – MESSAGES,
ABBREVIATIONS, & NAV TERMS
14-8
VLOC is not
responding
Internal system-to-system communication between the main processor and the VLOC receiver
has failed. Operational status of the VLOC receiver is unknown and the unit should be
returned to a Garmin dealer for service.
VLOC needs service
The GNS 430 has detected a failure in its VLOC receiver. The VLOC receiver may still be
usable, but the unit should be returned (at the earliest convenience) to a Garmin dealer for
service.
VLOC remote transfer
key is stuck
The remote VLOC transfer switch is stuck in the enabled (or pressed) state. Try pressing the
switch again to cycle its operation. If the message persists, contact a Garmin dealer for
assistance.
VLOC transfer key
stuck
The VLOC Flip-flop Key is stuck in the enabled (or pressed) state. Try pressing the VLOC
Flip-flop Key again to cycle its operation. If the message persists, contact a Garmin dealer for
assistance.
Waypoint already
exists
The name just entered for a user waypoint already exists in memory.
Waypoint(s) have been
replaced
One or more user waypoints were updated during a unit-to-unit crossfill operation.
Waypoint memory is
full The pilot has used all 1000 user waypoint locations in the GNS 430’s memory. Delete
unwanted waypoint to make room for new entries.