Garmin GNS 430 - Manual (Page 162)

GNS 430(A) Pilot’s Guide and Reference 190-00140-00 Rev. P 10-4
SECTION 10
AUX PAGES
Flight Planning Page: Fuel Planning
To perform fuel planning operations:
1) Select ‘Fuel Planning’ from the Flight Planning
Page, using the steps described in Section
10.2.
2) The current fuel planning ‘mode’ is displayed
at the top of the page (Figure 10-7): ‘POINT TO
POINT’ or ‘FPL’ (for a flight plan). To change
the mode, press the MENU Key to display the
Fuel Planning Page Menu (Figure 10-8) for the
other mode, then press the ENT Key to accept
the other mode.
Figure 10-7 Fuel Planning Page
Figure 10-8 Fuel Planning Page Menu
3) For point-to-point fuel planning (Figure 10-9),
turn the small and large right knobs to enter
the identifier of the ‘from’ waypoint. Once
the waypoint’s identifier is entered, press the
ENT Key to accept the waypoint. The flashing
cursor moves to the ‘to’ waypoint. Again, turn
the small and large right knobs to enter the
identifier of the ‘to’ waypoint and press the
ENT Key to accept the waypoint. OR,
Figure 10-9 Fuel Planning Page, Point-to-Point
4) For flight plan fuel planning (Figure 10-10), turn
the small right knob to select the desired flight
plan by number (already stored in memory;
00 is the active flight plan). Turn the large
right knob to highlight the ‘LEG’ field and
turn the small right knob to select the desired
leg of the flight plan, or select ‘Cum’ to apply
fuel planning calculations to the entire flight
plan.
Figure 10-10 Fuel Planning Page Flight Plan