EVS XTnano Version 11.01 - November 2012 Operation Manual - Manual (Page 22)

Issue
11.01.C
nano series Servers - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
14
4.1.5 IN
This function defines the IN point of a clip. The key will light differently depending on the
following situations:
Green key The key lights green if an IN point exists but is not the image you see.
Red key The key lights red if the on-air image is at this IN point. This point can
be entered while recording.
Flashing
(green or red)
key
In Split Audio mode, this key can be flashing green or flashing red.
Refer to the section Error! Reference source not found. ‘Error!
Reference source not found.’, on page Error! Bookmark not
defined. for more details.
During a Replace operation on a playlist, this key will flash red if trying
to insert an IN marker on a transition, as this is not allowed.
During an Extend operation on a timeline, this key will flash red until
you jog. At that time, it will flash green until the operation is confirmed
using the CAM D key.
4.1.6 OUT
This function defines the OUT point of a clip. This operates similarly to the IN button.
Modification of Clip IN / OUT Points
Select the clip that you wish to modify, use the jog dial to position the material at the new
IN or OUT point, and re-mark the IN or OUT point(s) as required.
Important
When IN/OUT points are set and a clip is saved, the system automatically write-
protects a user definable length of material before and after the IN/OUT points
respectively. These are referred to as the guardbands. Their duration can be set
with the Default clip duration parameter in the Operational Setup menu (p.2.2
F2) as required.
4.1.7 JOG KNOB
This function is used to accurately cue material.