EVS XTnano Version 11.01 - November 2012 Operation Manual - Manual (Page 96)

Issue
11.01.C
nano series Servers - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
88
9.15.2 Entering the Replace Function
A secondary menu with the Replace function has been added to the Playlist Edit mode.
Pressing MENU in Playlist Edit mode brings up the following menu:
OtherAng
Replace Redo Undo
Select Replace in this secondary menu to enter the Replace function.
9.15.3 Replace Edit and Replace Playback Modes
Similar to the playlist, the Replace function has two modes:
The Replace Edit Mode
This mode allows to specify the following information for the Replace:
• IN point and OUT point, for the section to replace in the playlist. The OUT point can
also be defined during the Replace itself.
• Loop mode parameters. See also the section ‘Loop Mode in the Replace Function’,
on page 90.
In the Replace Edit mode, the playlist is considered as one entity on which you can mark
one IN point and one OUT point (pressing the IN and OUT points does not retrim the
current playlist clip).
Those IN and OUT points will be used to determine what portion of the playlist will be
replaced.
The Replace Playback Mode
In this mode, you play the playlist back and insert the new section between the defined IN
and OUT points.
After you have selected the required settings for the Replace function, the Replace
Playback mode is automatically activated: the playlist is cued before the IN point (to
create guardbands), ready to be initiated.
The playlist is played at the speed defined in the playlist but the lever can also be used to
vary the playback speed.
When the Protect OUT point of the clip is reached, a clip containing the IN and OUT
points with the guardbands is created on the Receive page defined in the Setup menu.
The loop is stopped and the user switches back to match Frame Edit mode.