EVS XTnano Version 11.01 - November 2012 Operation Manual - Manual (Page 87)

nano series Servers - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
Issue
11.01.C
79
9.11 Adding Cut in Playlist Elements
9.11.1 Introduction
The Add cut command duplicates a playlist element (clip, record train...) and adjusts the
short-in and short-out points of these new duplicated elements.
On both these elements, the guardbands and other effects are kept unchanged as in the
original one.
In the first duplicated element, the short-in point is left unchanged while the short-out
point is adjusted to the cut point.
In the second duplicated element, the short-out point is left unchanged while the short-in
point is adjusted to the cut point as illustrated hereunder.
9.11.2 Adding Cut Behavior
When adding a cut to a clip, Multicam will behave as follows:
• The transition applied at the cut point is a cut (for both audio and video).
• The speed of the cut elements is the same as the original element, even if it is
“Unknown”.
• The stop and start modes of the cut elements are auto.
• Any loop defined on the playlist that includes the original element conserves and
includes the cut elements.
• Any tag defined and active on the original element at the cut point is recreated at the
short-in of the second cut element.
The adding cut is not possible in the following cases:
• Within a video effect.