EVS XTnano Version 11.01 - November 2012 Operation Manual - Manual (Page 81)

nano series Servers - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
Issue
11.01.C
73
9.9.3 Possible Methods for Adding Clips
You can add clips to a playlist in different ways:
• Adding clips at the end of the current playlist without entering the Playlist Edit mode.
See the section 9.9.4 ‘How to Quickly Add Clips to the Current Playlist’, on page 73.
• Inserting clips before or after the clip selected in the loaded playlist.
See the section 9.9.5 ‘How to Insert Clips into a Playlist’, on page 73.
9.9.4 How to Quickly Add Clips to the Current
Playlist
You can create a playlist very quickly. The experienced operator can include a clip at the
end of the playlist containing an action that happened seconds before the playlist is
played on air. To add clips quickly at the end of the current playlist, you do not have to
enter the Edit mode.
To add clips to the current playlist, proceed as follows:
1. Activate a playlist as the current playlist.
For more information, refer to the section 9.4.2 ‘How to Set a Current Playlist’, on
page 64
2. Recall the first clip for your playlist. For more information, refer to the section 8.2.3
‘Recalling a Clip’, on page 35.
3. Press ENTER on the Remote Panel.
The clip is added at the end of the current playlist.
4. Repeat as many times as necessary until the last clip is entered.
9.9.5 How to Insert Clips into a Playlist
The following rules apply to the procedure below:
• You need to be in PGM/PRV mode to be able to use the TAKE key on the Remote
Panel to insert a clip.
• Depending on what is selected for the Insert in playlist parameter in the
Operational Setup menu (p.3.1 F6), the clip will be inserted before or after this
selected position.
To insert a clip into a playlist, proceed as follows:
1. Using the Playlist Edit mode or the Browse mode, scroll to the location where the clip
must be inserted.
2. Call the selected clip. It appears on the PRV output.