VEGA VEGASON 54V…56V - Manual (Page 90)

90 VEGASON 54V … 56V
Setup - Adjustment with the PC on VEGALOG
In the menu field „ Backup“ the VEGALOG
with the serial number is displayed. You can
save the data of VEGALOG individually or in
groups with all settings in any directory on
your PC. It is also possible to add small
notes to each backup.
Furthermore you can save the settings of the
sensors:
Saved sensor data can be transferred to
other sensors at a later time.
If e.g. you have a system with several of the
same storage vessels and identical sensors,
it is sufficient, to configure one sensor, to
save the settings and then transfer them to
the other sensors.
The same is naturally valid for the VEGALOG
processing system.
• Choose the menu „
Services/Restore con-
figuration/Signal conditioning instru-
ments“.
In the yellow window cutout, you choose a
VEGALOG (or a sensor) which should be
overwritten with the settings of another VE-
GALOG.
Choose in the field „ Selection of backup“ the
serial number of the VEGALOG of which you
want to take over the settings. With „
Restore
after“ you transfer these VEGALOG settings
to the VEGALOG you have chosen in the
yellow window cutout.
Linearisation
See chapter „6.2 Adjustment with the PC on
VEGAMET“ under „Linearisation“.
Simulation
See chapter „6.2 Adjustment with the PC on
VEGAMET“ under „Simulation“.
Change COM interface
See chapter „6.2 Adjustment with the PC on
VEGAMET“ under „Change COM interface.
Show measured value
See chapter „6.2 Adjustment with the PC on
VEGAMET“ under „Show measured value“.