VEGA VEGALOG 571 - Manual (Page 25)

VEGALOG 571 25
2 Mounting
2.1 Carrier
The module cards of VEGALOG 571 must
only be mounted into the 19“-carrier BGT
LOG 571, because only this carrier is pro-
vided with a special bus board for data
transmission between the CPU and the indi-
vidual peripheral cards of VEGALOG.
A VEGALOG 571 can consist of max. two
completely equipped carriers which are
connected via a pluggable bus line (see
3 Electrical connection). As the extension of
the pluggable bus cable is not allowed, both
carriers must be mounted directly one above
the other.
Note:
In the following cases we recommend the
mounting of a ventilator to prevent a tempera-
ture increase in the VEGALOG:
- when more than one carrier are mounted
one above the other
- when more than 2,5␣ W/TE are consumed in
the carrier
- when there is no air circulation in the range
of the carrier
Mounting
2.2 Mounting in carrier
The carrier BGT LOG 571 is supplied com-
pletely assembled. For mounting of the indi-
vidual module cards you only have to place
the modules in the required positions. A mod-
ule consists of:
- a multipoint connector acc. to DIN 41 612,
series F, 48-pole (d, b, z)
- two screws
- two coded pins
- two guide rails.
The multipoint connector is available in the
following versions:
- Wire-Wrap standard connection
1,0 mm x 1,0 mm
- Plug connection 2,8 mm x 0,8 mm
- Termi-Point standard connection
1,6␣ mm␣ x␣ 0,8␣ mm
- Soldering connection
- Screw terminals 0,5 mm
2
Please note the operating instructions of the
carrier BGT LOG␣ 571, for mounting the mod-
ule.
19" = 482,6
465
84 TE = 426,72
57,1
132,5
10,5
7,5
258
3
185
Ventilator