VEGA VEGALOG 571 - Manual (Page 42)

42 VEGALOG 571
Now you have to add a name for the meas-
urement loop. Enter in the fields “Meas. loop
No.“ and “Measurement loop description“,
names which clearly identify the measure-
ment loop. It is also possible to configure the
outputs. Depending on the VEGALOG equip-
ment, different output modes are available,
for example,
current output ( fault signal is
only active when under “Configuration meas-
uring system“ at least one switching output
was defined as fault signal output).
Here you can initially choose the card
number (if you have several current output
cards available), then click on the output
numbers and co-ordinate with
>> to the
measurement loop. It is possible to undo this
co-ordination. When you have finished the
current outputs, click on
OK . Proceed in the
same way for the other outputs. It is also
possible to adjust the mode (standard - reset
of alarm functions - hold function) with relay
outputs.
In this window, you can clearly see the con-
figuration of your measurement loop. Click to
OK .
You have here again the possibility to undo
the measurement loop configuration. Other-
wise click on
OK . Your measurement loop
configuration is then saved and you see the
main window of VVO again.
After you have finished the measurement
loop configuration, you can start with the
parameter adjustment of the measurement
loop. Click on
Instrument data , then on
Parameter adjustment . In the window “Se-
lection of measurement loop - Parameter
adjustment“, you can then select a measure-
ment loop and confirm with
OK .
Set-up