VEGA VEGAMET 514V - Manual (Page 15)

VEGAMET 514V 15
Adjustment
4.5 Comparison: reduced menu – extended menu
In the table, the most important functions of VEGAMET 514V are listed – with the information in
which menu mode the functions are available.
Function Reduc. Ext.
menu menu
Adjustment with medium x x
Adjustment without medium x x
Set integration time x x
Simulation x x
Change over current output (4/20 mA, 0/20 mA, 20/4 mA, 20/0 mA) x x
Change over volt output (2/10 V, 0/10 V, 10/2 V, 10/0 V) x x
Changeover relay mode (overfill protection – dry run protection) x x
Scaling (display) x x
Change menu language x x
Activate/deactivate password x x
Change sensor type x x
Change measurement loop name x x
Reset measurement loop (Reset TAG) x x
Reset measurement loop to default (TAG to default) x x
Use correction input – x
Edit linearisation curves – x
Change mode (e.g. level – gauge) – x
Select different reference values for outputs – x
Define output behaviour (current/Volt output) in case of failure – x
Offset correction during adjustment – x
Adjust relay switching delay – x
Reset level – x
Assign inputs (from another VEGAMET) – x
Switch on/off current/Volt limitation – x
Individual setting of current/Volt output values between 0 … 20 mA/0 … 10 V – x
Manual offset correction – x
Manual real value correction – x
Info indication – x
Assign outputs to measurement loop
(current, Volt, PLC, DIS, relay outputs)
– x
Choose further relay modes (switching window, tendency determination) – x