VEGA VEGAMET 514V - Manual (Page 26)

26 VEGAMET 514V
Level measurement
Level measurement
Gauge measurement
Gauge measurement
Pos. A
Pos. A Pos. A
Pos. A Pos. A Pos. A
In the menu items "Pos. D“ and "Pos. E“ you
can state if input 4 is used for one of the
stated correction modes (input4 is the cor-
rection signal input on terminals 22d and
24d). You then have to enter a value at which
the correction should be carried out under
"Parameter adjustment“ –– "Special funct.“ in
the menu items "Real value correc. at…“ or
"Density correc. at…“.
Note!
Input 4 can also be used for tare and moni-
toring. However, it is not possible to use it at
the same time for tare, monitoring and, for
example, density correction!
Settings in the "extended menu“
In the menu item "TAG name“ you can assign
an individual name to the measurement loop.
If you choose "Fault signal off“ the fail safe
relay and the failure LED on the front plate will
be nonoperable. For a description of the
correction modes, see the following pages.
TAG 1
Level
Appli-
cation
Level
Sensor
type
Hydro-
static
Mode
Stan-
dard
Option
no
option
Sensor
coordi-
nation
Posi-
tion A
In-
put1
Ultrasonic
Radar
TAG 1
Pegel
Appli-
cation
Gauge
Sensor
type
Hydro-
static
Mode
Stan-
dard
Option
no
option
Sensor
coordi-
nation
Posi-
tion A
In-
put1
Ultrasonic
Radar